Table of Contents
Advertisement
Divar XF
4
Hardware setup
This chapter contains detailed information about the hardware installation and connection of
external equipment to the unit. The connector types and their pin signals are described. Most
of the connectors are located at the rear panel of the unit. For convenience, one USB port is
located on the front of the unit to connect a mouse or memory device.
All the input/output ports are Safety Extra Low Voltage (SELV) circuits. SELV circuits should
only be connected to other SELV circuits.
4.1
Desktop installation
Place the unit on a stable, flat surface. Install the two supplied silver side covers by:
1.
2.
Figure 4.1 Side cover installation
4.2
Rack mounting
The unit can be mounted in a 19-inch rack. A rack mounting kit is supplied with the unit that
includes two rack mounting brackets.
Mounting
1.
2.
3.
4.
Figure 4.2 Securing the rack mounting bracket
Bosch Security Systems
inserting them on each side,
sliding them towards the front of the unit.
Remove the four cross head screws (two on each side) located near the front panel on
the right and left side of the unit.
Secure the supplied brackets to each side using the same four cross head screws (two
on each side) that were just removed.
To install several units directly on top of each other, remove the rubber feet from under
the unit by prying them loose with a small screwdriver.
Install the unit into the rack using the hardware supplied with the rack and following the
rack manufacturer's instructions.
Installation manual
Hardware setup | en
23
F.01U.135.429 | 2.5 | 2009.08
Advertisement
Table of Contents
