Table of Contents
Advertisement
64
en | Advanced configuration menu
–
Sound beeper on alarm
–
Sound beeper on video loss
–
Actions when entering this profile
Click Edit... to specify pre-positions for PTZ cameras when this profile is started.
–
Any actions that have been configured are listed.
6.7.2
Contact
The event behavior can be configured for each of the 16 input contacts in turn.
–
–
Actions
Click Edit... to set up Recording, Monitor and PTZ actions that should be carried out when
this contact is active.
–
–
–
Any actions that have been configured are listed.
6.7.3
Motion
The event behavior for motion detection can be configured for each video channel in turn.
–
–
Actions
Click Edit... to set up Recording, Monitor and PTZ actions that should be carried out when
motion is detected.
–
–
–
Any actions that have been configured are listed.
6.7.4
Video loss
The event behavior for video loss signals can be configured for each video channel in turn.
–
F.01U.135.429 | 2.5 | 2009.08
Follows - activates the beeper, relay, and view only as long as the event is present.
Enable an audible warning upon an alarm.
Enable an audible warning upon video loss.
Enter a pre-position value from 1-1023 for each of the PTZ cameras that should be moved
(PTZ must be enabled for corresponding camera input).
Check the Enabled box if the input contact should activate an event.
Check the Alarm box if the input contact should activate an alarm.
Recording: highlight the video channels to be recorded at contact recording settings
when this input contact is active (highlight the un-numbered box to select all). A list of
the selected channels and their recording properties is shown.
Monitor: highlight the video channels to be displayed on monitors A and B when this
input contact is active (highlight the un-numbered box to select all).
PTZ: enter a pre-position value from 1-1023 for each of the PTZ cameras that should be
moved (PTZ must be enabled for corresponding camera input).
Check the Enabled box if motion detection should activate a trigger.
Check the Alarm box if motion detection should activate an alarm.
Recording: highlight the video channels to be recorded at motion recording settings
when motion is detected (highlight the un-numbered box to select all). A list of the
selected channels and their recording properties is shown.
Monitor: highlight the video channels to be displayed on monitors A and B when motion
is detected (highlight the un-numbered box to select all).
PTZ: enter a pre-position value from 1-1023 for each of the PTZ cameras that should be
moved (PTZ must be enabled for corresponding camera input).
Check the Enabled box for each video channel if video loss should activate a trigger.
Installation manual
Divar XF
Bosch Security Systems
Advertisement
Table of Contents
