Table of Contents
Advertisement
Divar XF
3.
4.
5.
6.
7.
6.5
Contacts
Use the Contacts menu to set up alarm inputs and relay outputs.
Figure 6.6 Contacts menu
6.5.1
Contact inputs
By default, all contact Inputs are Normally Open (NO). Highlight contact inputs that you wish
to function as Normally Closed (NC) contacts (highlight the un-numbered box to select all).
6.5.2
Relay outputs
By default, all relay output contacts are Normally Open (NO). Highlight the relay outputs that
you wish to function as Normally Closed (NC) contacts.
6.5.3
Contact input properties
Each of the 16 contact inputs can be assigned a name and a profile override mode.
Profile overrides
An alarm input can activate a profile override. There are three modes available:
–
–
Bosch Security Systems
Highlight the profiles to copy to (highlight the un-numbered box to select all).
Select the camera input(s) to be copied from, for the profile to be copied.
Select the camera inputs to be copied to (hightlight the un-numbered box to select all).
Check only those recording modes (Normal, Alarm or Motion) that you wish to copy.
Click Copy.
No override (default)
Follows: the profile override lasts for as long as the input is active (no override duration
can be set).
Installation manual
Advanced configuration menu | en
F.01U.135.429 | 2.5 | 2009.08
61
Advertisement
Table of Contents
