Table of Contents
Advertisement
24
en | Hardware setup
CAUTION!
When installing the assembly into the rack, be careful not to restrict air flow around the vents
located on the side panels or to exceed the recommended operating temperature.
Secure the connection cables to the rack to relieve excessive weight to the back of the unit.
4.3
Hard disk installation
Up to four hard disks can be installed in the DVR. All hard disks are accessed from the front of
the unit by removing the front panel. Do not open the top cover or attempt to service the unit.
No user serviceable parts inside. Refer all servicing to qualified service personnel. Improper
handling or installation could void the warranty of both the hard disk and the DVR.
Note! Only genuine Bosch hard disks will work in the Divar XF. See the Bosch website or
contact your local Bosch representative for available hard disks.
CAUTION!
Electrostatic discharges
Any electrostatic energy coming in contact with the hard disk or other sensitive internal parts
can damage them permanently. Improper handling could void the warranty of the hard disk.
When working with electrostatic sensitive devices such as a hard disk or the Divar unit, make
sure you use a static-free workstation.
4.3.1
Mounting instructions
DANGER!
Electrical voltage.
Risk of electric shock.
Before installation of the hard disk, unplug the power cord of the DVR and wait for at least 30
seconds.
Removing the front panel
Figure 4.3 Front panel removal
1.
2.
3.
F.01U.135.429 | 2.5 | 2009.08
Loosen the two captive cross head screws on the bottom front panel.
Slide the front panel to the right until it is free.
Place the front panel on top of the unit, taking care not to strain the flat cable. If there is
no room on top of the unit, disconnect the flat cable and set the front panel aside.
Installation manual
Divar XF
Divar
Bosch Security Systems
Advertisement
Table of Contents
