Changing The Print Offset - Kodak i1840 User Manual

Changing the print offset

A-61555 May 2010
The Print Offset function allows you to temporarily move the print
location on a document (e.g., if you need to rescan a document that has
already been printed on). This function is only available when the
scanner is enabled.
When you change the print offset position, the change will stay in effect
until the scanner returns to the Idle state.
NOTES:
• The Print Offset option is only displayed on the OCP if the printer is
enabled.
• If your scanner is configured to auto start, it is recommended that you
disable autostart if you want to use the Print Offset function for the
first document.
• For more efficient scanning, it is recommended that you set the
scanner to Pause Scanning (in the capture application software)
when a multifeed occurs so the scanner will stay enabled.
• If you set the Print Offset to a dimension that is longer than your
document, there will be no printing on your document.
1. Enable the scanner and Print functionality via the capture
application software. When the scanner is enabled, the following
screen will be displayed.
NOTE: The number displayed in the window is the additional offset
from what was set by the host application. This number is 0
if the print offset has not been changed by the operator.
3-35