Kodak i1840 User Manual page 90

A-61555 May 2010
If you want to replace the tires, proceed as follows:
6. With one hand, press the locking tabs (one on each side) while
holding the bottom housing with the other hand, pull the upper
housing up and away from the rollers.
7. Remove one core assembly.
8. Replace each tire by sliding the tire off the core.
9. Install each new tire by gently pulling it over the core. The tires do
not need to be installed in any specific orientation.
IMPORTANT:Do not overstretch the tire; it may tear.
10. Replace the core assembly in the lower feed module housing.
11. Repeat the replacement procedure outlined above for the other core
assembly.
Locking tab
5-17