Changing Print Positions - Kodak i1440 User Manual

Changing print
positions
4-10
The horizontal print position can be changed manually.
NOTE: Changing the print position is the same procedure whether you
are using the Document Printer or the Enhanced Printer. The
illustrations may be slightly different depending on the printer
you are using.
1. Locate the printer access door on the back of the scanner.
2. Slide your fingers under the printer access door handle and pull the
door toward you.
3. Lift the printer access door off the scanner.
NOTES:
• Even though there are 14 horizontal print positions, if you are
using the Enhanced Printer, you can only print in 9 of the
positions.
• If you are using the Document Printer, all 14 print positions are
available for printing.
• These positions are visible by a small detent on the printer rail.
• Printing automatically stops approximately 1.27 cm ( ½-inch) from
the trailing edge of the document even if the information has not
been completely printed.
4. Lift up on the printer carrier and remove it from position.
5. Align the slot on the printer carrier with the desired position and
slide the printer carrier in place.
6. Reinstall the printer access door.
A-61550 February 2010