5-12
4. Holding onto the separator module, rotate the release lever back so
you can access the separator roller.
NOTE: Use caution as the separator module is spring-loaded and
will snap back if you do not hold it in place.
5. Hold onto the separator module in this position with one hand, and
with the other hand remove the separator roller.
6. Gently lower the separator module release lever back into place and
set the separator module aside.
7. Remove each tire by sliding it off the core.
8. Install each new tire by gently stretching it over the core.
IMPORTANT: Do not overstretch the tire; it may tear.
Make sure that the tire is centered on the core and lies
flat.
9. Reinstall the core (the direction does not matter).
10. Reinstall the separator module.
11. Close the scanner cover with both hands; push it down firmly until it
latches into place.
A-61550 February 2010