Fujitsu fi-5950 Operator's Manual page 103

4. Select the detection conditions from [Multifeed Detection] under [ADF
Option].
You can choose the following:
None
Check overlapping
Check length
Check overlapping
and length
Hardware settings
Furthermore, refer to
information about the document for multifeed detection.
5. Click the [OK] button.
The display returns to the [TWAIN Driver] dialog box. Then, perform the scanning operation
on the dialog box.
The scanner will stop scanning if a multifeed is detected. When this happens, press the [Send
to] button on the Operator panel to eject the multifeed document.
Multifeed detection is not performed.
The scanner monitors for the overlapping of documents. The scanner detects a
multifeed by differences in ultrasonic propagation. When this method is
slected, two more options are available specified by other sections.
• Multifeed detection areas can be narrowed separately for left/middle/right
Ultrasonic sensors to avoid unintensional multifeed detection of sticked pho-
togragh or something on the document. To specify this, go to Step 4 in Sec-
tion "8.4 Multifeed Detection" on page
• If photogragh or something is sticked on the document and its size and/or
position are same, you can easily let the scanner memorize its size and/or
position just scanning those document. To use this function, go to Section
"8.10 Intelligent Multifeed Function" on page 202
detecting Multifeed for fixed format" on page
The scanner monitors the length of documents. It detects a multifeed by differ-
ences in the document length when two or more document sheets are fed over-
lapping.
The scanner monitors both document overlapping and length to detect
multifeeds.
The scanner will detect multifeeds according the settings configured on the
Software Operator Panel. Refer to
"7.5 Multifeed Detection Conditions" on page 164
190.
or Section
95.
"8.4 Multifeed Detection" on page
for detailed
3.7 Detecting Multifeeds
3
"3.12 Not
190.
83