Setting The Hopper Height - Fujitsu fi-5950 Operator's Manual

2.5 Setting the Hopper Height

When there is no alarm (the function number display is showing "1"), the Hopper height can be adjusted.
When the scanning load is not very heavy, setting the hopper higher will shorten the time it moves to the
feeding position.
ATTENTION
Adjustment is not possible when:
The scanner is scanning
•
The hopper is closed.
•
• When using Software Operation Panel (see
Three hopper heights are available and the corresponding capacities are as follows.
High: Up to 100* sheets
Middle: Up to 300* sheets
Low: Up to 500* sheets
*: Estimated using paper of 80g/m
HINT
• Do not touch the hopper when it is being adjusted. Your finger(s) may
be pinched.
• Do not load anything onto the hopper when it is moving. If something
gets into the mechanism, the scanner may be damaged.
• Do not place anything under the hopper. The hopper may collide with it
and become damaged.
• Do not press the [Hopper Height] button (
closed. The hopper may be damaged.
2
(20lb).
Depending on the thickness of the document, the loading capacity differs.
Refer to "7.3 Maximum Document Loading Capacity" on page
) when the hopper is
page 173).
High
Middle
Low

2.5 Setting the Hopper Height

2
162.
15