Related Manuals for Antra AH6-260 Series
Summarization of Contents
Safety Warnings
Signal Word Definitions
Explains the meaning of Danger, Warning, Caution, and Notice symbols used in the manual.
Arc Rays, Fire, and Explosion Hazards
Covers eye damage from arc rays and fire/explosion risks from welding sparks and hot materials.
Fumes, Gases, and Chemical Hazards
Addresses health risks from welding fumes, gases, and chemicals, including California Proposition 65.
Additional Safety Precautions
Eye Protection from Flying Metal
Advises wearing safety glasses with side shields under the welding helmet to protect from flying metal.
Burn Prevention from Hot Parts
Warns against touching hot parts bare-handed and recommends cooling periods before handling.
Hearing Protection from Noise
Recommends ear protection when noise levels from welding processes may damage hearing.
General Information and Marking Explained
General Information
Provides overview of the helmet's capabilities, limitations, and usage guidelines for welding applications.
Marking Explained
Illustrates and explains the markings found on the welding filter, referencing EN379 standards.
Pre-Operation Checks and Warnings
Important Pre-Use Warnings
Critical warnings for storage, inspection, skin contact, hot surfaces, and filter cartridge handling.
Parts List
Lists all components of the welding helmet for identification and replacement.
Helmet Operation and Adjustment
Adjusting Helmet Fit and Angle
Guides on adjusting headband for circumference, height, and helmet-to-face angle.
Personalized Headband Adjustment
Instructions for using adjustment knobs for customized headband width and height.
Shade Number Selection and Settings
Select the Shade Number
Instructions on how to select the appropriate shade number for welding and grinding modes.
Recommended Settings Chart
Provides a chart with recommended shade settings for various welding processes and current amperages.
Delay and Sensitivity Control
Delay Time Control
Explains how to adjust the delay time for the lens to lighten after welding, from 0.1 to 1.0 seconds.
Sensitivity Control
Details how to adjust sensitivity for optimal response to welding arcs in various conditions.
Pre-Welding Checks and Battery Testing
Auto-Darkening Operation
Describes the ON/OFF function of the solar unit and how it reacts to light exposure.
Battery Testing Procedure
Step-by-step guide to test the auto darkening lens functionality using the battery test button.
Maintenance and Component Replacement
Battery Replacement
Instructions for safely replacing the batteries in the auto darkening filter cartridge.
Front Cover Lens Replacement
Guides on how to remove and replace the outer protective lens cover of the welding helmet.
Inner Cover Lens Replacement
Steps for removing and installing the inner protective lens cover on the filter cartridge.
Filter Replacement Procedures
Front Cover Lens Retainer Removal
Detailed steps to remove the retainer holding the front cover lens using lugs.
Filter Removal and Installation
Instructions for safely removing the auto darkening filter and installing it back into the helmet.
Exterior Cover Lens Replacement
Exterior Cover Lens Replacement
Guides on how to remove the old exterior cover lens and install a new one onto the helmet shield.
Inspection and Troubleshooting
Regular Inspection
Emphasizes regular inspection of the filter for damage to ensure proper protection and vision.
Cleaning and Disinfection
Guidelines for cleaning the helmet and welding filter using mild soap and water, avoiding solvents.
Trouble Shooting Common Issues
Provides solutions for common problems like filter not darkening, flickering, or slow switching.
Warranty and Distributor Information
Warranty Information
Details the product warranty, limitations, and recommended usage period for the welding helmet.
Distributor Information
Lists the distributing company and its contact details for support and inquiries.
Need help?
Do you have a question about the AH6-260 Series and is the answer not in the manual?
Questions and answers