Subscribe to Our Youtube Channel
Related Manuals for Antra AH6000 Series
Summary of Contents for Antra AH6000 Series
- Page 1 Customer Sevice AH6000 SEREIES Technical Info. Parts & Accessories Promotions X60-2D www.facebook.com /AntraHelmets Auto-Darkening Welding Helmet User Manual Made in china 2018...
-
Page 2: Important Safety Instructions
AH6000 SEREIES ARC RAYS can burn eyes ! Never look at arc welding without proper eye protection. Arc rays from the X60-2D welding process produce intense visible and invisible (ultraviolet and infrared) Auto-Darkening Welding Helmet User Manual rays that can burn eyes and Skin, Hot sparks fly off from the weld and can burn eyes and skin. -
Page 3: Technical Specifications
Meaning of the marking for EN 379: FLYING METAL can injure eyes ! Model Standards • Welding, chipping, wire brushing, and grinding cause sparks and flying metal. As welds cool, they can throw off slag. Serial number Optical Specifications • Wear ANSI approved safety glasses with side shields under your welding helmet. HOT PARTS can cause severe burns ! •... -
Page 4: Parts List
MEANING OF THE MARKING FOR EN 175 Identification of the manufacturer When stored in extremely cold temperature, the helmet should be warmed up to • Number of the standard ambient temperature before welding. Inspect all parts for signs of wear or damage. Any scratched or cracked parts should be •... -
Page 5: Recommended Settings
RECOMMENDED SETTINGS ON/OFF The solar unit automatically switches ON when exposed to light. 2. SELECT THE SHADE NUMBER Shade 8 Shade 9 Shade 10 Shade 11 Shade 12 Shade 13 Shade 14 Shade 11 Shade 12 Shade 13 Shade 14 Shade 15 1）... -
Page 6: Maintenance
4. PRE-WELDING CHECK & BATTERY TESTING NEVER put used batteries into house hold waste. Please always have used batteries recycle properly. The following procedures should be followed to perform this testing: 1) Make sure there is enough ambient light to trigger the auto darkening lens on. -
Page 7: Troubleshooting
6.INSPECTION 1. Carefully inspect your Auto-Darkening Welding Filter regularly. 2. Cracked, pitted or scratched filter glass or cover lenses reduced vision will seriously impair protection. 3. Worn parts should be replaced immediately to avoid injury to the eyes. CLEANING AND DISINFECTION (Fig.15) (Fig.16) Clean the helmet with mild soap and lukewarm water. -
Page 8: Warranty
If the described malfunctions cannot be solved, stop using the helmet immediately and contact the nearest distributor. 1. Please do not operated if the temperature below -5 ℃（+23℉）. 2. This product should not be used for over-head position welding. If this product is used for over-head welding, molten metal could drop and cause welder injury.
Need help?
Do you have a question about the AH6000 Series and is the answer not in the manual?
Questions and answers