B Trim - Denon DN-HS5500 Owner's Manual

Exit/Reloop
r In Seamless Loop playback, you
can force exit from or return to
the loop.
EXIT:
While the Seamless Loop
5
playback, push the EXIT/RELOOP button to
exit from loop. DN-HS5500 continues playback
after the B point.
RELOOP:
When the EXIT/RELOOP button is pushed after
exit the loop, Seamless Loop playback
resumes from the A point.
Stutter
• A1 and A2 points can be also used for Stutter
playback.
t To enable stutter playback, push
6
FLIP button for A1/A2 buttons,
then " " display turns off.
Press the FLIP button to switch
between the Hot Start/Seamless
Loop and Stutter modes.
Clear the A1/A2 point
y While pressing the FLIP/(CLR) button, push the
A1 or A2 button to clear the corresponding A
and B points.
Or push the FLIP button for more than 1 sec to
clear both A1 and A2 points at once.
Quickly pressing the "FLIP" button first and
then A1, A2 or B buttons will clear these points
individually.
7
• If the device has been changed in the file
playback mode or if the playlist has been
changed in the playlist playback mode, the
A1 and A2 points are cleared by force.
11 A/B TRIM
• The Seamless Loop A and B points can be fine-adjusted using the scratch disc.
• Trim the points during loop playback as a rehearsal.
DECK1/2
HOT LIST
ADD OMIT
AUTO/INPUT BPM
LOCK
A/B Trim
q When the A/B TRIM button is
pressed during seamless loop
playback, the A/B TRIM mode
1
is turned on.
To cancel A/B TRIM mode,
press the A/B TRIM button again.
Select A or B point
w Press the A1 or A2 button to
select point A. Press the B
2
button to select point B.
✽ The loop that can be adjusted
is the currently playing loop.
Trim A or B point
e Turn scratch disc slowly to
move the A or B point 1
frame at a time.
• Range for trimming A or B
3
point is limited as follows.
±30 frames of point A and
up to 5 frames before point B
B point for Loop:
Between 5 frames after A point and file end.
18
ENGLISH
NEXT FILE B w,r
MIRROR
q
MEMO
PRESET
FAST SEARTCH e
DECK1:ORANGE
DECK2:GREEN
Save the A or B point
r Push the flashing A button
4
again to save new A or B point,
and the unit automatically exit
from the A/B Trim mode.
ENGLISH