Recovering The Firmware Of The Hard Disk Player - Aiwa MUSIC TRANSFER Operating Instructions Manual

Recovering the firmware of the hard
disk player
If an error message appears in the player's display repeatedly even after you have reset the
player, you can use the following procedure to recover the firmware of the player.
1
Turn on the player, and then connect the player to your computer.
In case the player is not recognized, turn off the player with the USB cable connected, and
then turn on the player again. If it is not possible to turn off the player, reset the player, and
then turn on the player.
2
Insert the Music Transfer Hard Disk Player Edition CD-ROM into the CD-ROM
drive of the computer.
The setup program starts automatically and the installation window appears.
If the setup program does not start automatically, double-click [Launcher.exe] included in
the CD-ROM using Windows Explorer.
3
Click and select a language, and then click [Select].
Select a language to be used by the software for displaying menus and messages.
4
Click [Firmware Recovery].
5
Follow the displayed instructions.
If the firmware recovery operation does not solve the problem, refer to "Troubleshooting" in the
operating instructions for the hard disk player as well as "Troubleshooting" in this manual. If
the problem persists, consult your nearest Aiwa dealer.
Note
If you perform the firmware recovery operation, all the files sent to the player using Music Transfer Hard
Disk Player Edition and the settings you have made on the player will be erased.
22 GB