Step 3: Set The Scsi Address - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual

Chapter 1
Figure 1-6. Component Identification, Type 5 Drives
J3
Figure 1-7. Component Identification, Type 6 Drives

Step 3: Set the SCSI Address

The SCSI address is set using jumpers located on the drive. SCSI addresses range
from 0 to 15.
Each drive is preset to SCSI address 3.
Address 7 is reserved for communications with the SCSI host bus adapter.
Set the drive to the lowest available SCSI address. Address 0 should be used for
the first drive in the system. Typically, address 1 is assigned to the second hard
disk drive, address 2 is assigned to the third drive, and so forth.
8
Prepare Drive for Installation
SCSI
Connector
Power
Connector