A Jumper Settings; Jumper Legend - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual

A Jumper Settings

The hard disk drives are shipped without SCSI terminators. These drives are ready
to use on a SCSI cable with a built-in active terminator.
Each hard disk drive is configured at the factory for optimum performance on
most systems. With the possible exception of setting the SCSI address, you should
not change default settings. Changing the disk drive configuration can cause
unexpected or undesirable results.

Jumper Legend

Table A-1 lists descriptions of jumper abbreviations for all drives. All jumper-
controlled features are not available on all drives. (An * indicates a factory default
setting.)
Table A-1. General Jumper Description
ID Description
Ax SCSI Addresses (A0, A1, A2 and A3)
LED Light Emitting Diode Drive Activity Light
DS Delay Spin-Up
On*
Off
See the "Set the SCSI Address" step in the chapter "Prepare
Drive for Installation" for detailed information.
Not a jumper in the traditional sense. This is where the drive
activity light connects to the drive.
Motor start up is delayed by the sum of the SCSI ID times 6
seconds after power is applied; i.e., Drives 0 and 8 spindles
start immediately, drives 1 and 9 start after a 6 second delay,
drives 2 and 10 start after a 12 second delay, and so forth.
Motor start up begins immediately after system power up,
unless Motor Start Enable is on. If Motor Start Enable is on, it
overrides this setting.
25