Adding To An Existing System - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual

7. Install the Adaptec Management Controller device when prompted.
Completing the installation requires that the system shutdown and restart. When the
restart is complete, continue with the following steps to complete the installation.

Adding to an Existing System

1. Follow the instructions for installing the Adaptec SCSI RAID controller in your
system. Refer to Chapter 3, "Installing the Controller."
2. Before you start your installation, insert the HP start-up CD on a Windows
platform, and follow instructions for creating a driver floppy for the 2100S.
3. When you start Windows 2000 the Found New Hardware Wizard will start for a
SCSI/RAID Controller. Insert the driver floppy into your floppy drive. Select the
floppy as the source, then click Next.
4. Click Next in the next two windows that appear.
5. Follow the on-screen instructions to complete the Adaptec SCSI RAID
installation.
6. Install the Adaptec Management Controller device when prompted.
IMPORTANT: If you reset the NVRAM on the controller, any changes to your cache settings
return to the factory default.
HP 2100S SCSI RAID Controller User Guide
Installing Adaptec SCSI RAID Software
4-3