System Requirements; Working With Electricity; Preventing Electrostatic Discharge - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual

Introduction

System Requirements

All Adaptec SCSI RAID controllers are PCI 2.2 compliant and are designed to
operate in host systems that comply with revision 2.2 of the PCI Local Bus
Specification.
Adaptec SCSI RAID controllers are also multifunction PCI devices. The host system
must be able to properly configure multifunction PCI devices, where one of the
devices is a bridge.
You must use cables designed for Ultra160 SCSI and active termination for your
SCSI bus.

Working with Electricity

Any device that uses electricity must be treated with caution. Follow these guidelines
to ensure general safety:
·
Keep the chassis area clear and dust-free during and after installation.
·
Do not perform any action that creates a potential hazard to people or makes the
equipment unsafe.
·
Before working on the system, unplug the power cord.
— Disconnect all power before doing the following:
— Installing or removing a chassis
— Working near power supplies
·
Do not work alone when potentially hazardous conditions exist.
·
Never assume that power has been disconnected from a circuit. Always check.
·
Look carefully for possible hazards in your work area, such as moist floors,
ungrounded power extension cables, or missing safety grounds.

Preventing Electrostatic Discharge

To prevent electrostatic discharge, refer to Appendix B, "Electrostatic Discharge."
1-2 HP 2100S SCSI RAID Controller User Guide