This appendix provides answers to many Frequently Asked Questions (FAQ). If a
situation occurs that is not covered in this appendix, or if the recommendations here
do not correct the problem, contact a technical support representative.
Problem 1
When the Adaptec I
fails to appear.
Solution 1
The following conditions can cause this to occur:
•
The device ID might be set to the same ID as the Adaptec controller (ID 7).
Ensure that all devices have a unique ID.
•
The device might not be powered on.
•
The device is not connected to the SCSI cable or the connection is loose.
HP 2100S SCSI RAID Controller User Guide
O BIOS displays the peripheral devices at system boot, a device
2
Troubleshooting
C
C-1