Problem 7; Solution 7; Problem 8; Solution 8 - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual

Problem 7

The controller fails to respond and one of the following patterns of LEDs flash once
per second at power-up:
•
7, 6, 5, 2, 1 None
•
7, 6, 5, 3, 1 High
•
7, 6, 5, 3, 2 Mismatch
•
7, 6, 5, 3, 2, 1 Invalid

Solution 7

These patterns indicate a problem with the memory modules on the controller.
None—Either no memory modules were detected on the controller, or there is no
module installed.
High—Too much memory has been detected on a controller. Remove memory so
that the total is less than or equal to 128 MB.
Invalid—A memory module smaller other than 32, 64, or 128 MB has been detected.
Use only 32, 64 or 128 MB capacity memory modules.

Problem 8

The controller fails to respond and various LEDs in the 1–4 range flash once per
second.

Solution 8

This pattern indicates an internal microprocessor trap occurred in the controller.
Remove all attached devices, cables and retry. If the trap error disappears, reconnect
the cables and devices, one device at a time, until the faulty device or cable is
isolated. If the error persists, contact your technical support representative.
HP 2100S SCSI RAID Controller User Guide
Troubleshooting
C-5