Channel Level; Fader Function - Denon AVR-989 Owner's Manual

Operations
1
Connect the HDMI to the AVR-989 with equipment
compatible with the HDMI control function (vpage
58).
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b Please consult the operating instructions for the connected
equipment to check the settings.
b Steps 1~3 do not have to be repeated once started.
b Carryout steps 2 and 3 should any of the equipment be plugged
out.
4
Switch the television input to the HDMI connected to
the AVR-989.
5
Switch the AVR-989 input to the HDMI input source
and check if the picture from the player is ok.
6
Put the television power on standby and check if the
AVR-989 goes into standby.
If the AVR-989 does not work please check the following.
• Is the menu "Manual Setup" – "HDMI Setup" – "HDMI Control"
(vpage 30) set to "ON"?
• Is the menu "Manual Setup" – "HDMI Setup" – "Power Off Control"
(vpage 30) set to "ON"?
• Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
• Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat step's 2 and 3.
Menu "Input Setup" – "Assign" – "HDMI In" (vpage 38) setting
•
has changed.
There is a change to the connection between the equipment and
•
the HDMI, or an increase in equipment.

Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<STANDARD> <DSP SIMULATION>
<POWER> CH SELECT/ENTER
[Front]
QUICK SELECT
CH SELECT/
ENTER
uiop

Channel Level

You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
BUTTON
1
<BUTTON>
CH SELECT/ENTER
Press
[BUTTON]
uio p
2
Use ui or
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
QUICK SELECT
b In the case of a subwoofer, reducing the volume when it is at "–12
[Rear]
dB" will change the setting to "OFF" (none).
NOTE
When the input source is "iPod", you cannot perform channel level
setting.

Fader Function

This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
1
CH SELECT/ENTER
Press
uiop
CH SELECT/
ENTER
2
Press ui or
3
Use o p to adjust the volume of the speakers.
(o: front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
.
Channel Volume
FL 0.0dB SR 0.0dB
C 0.0dB SBR 0.0dB
FR 0.0dB SBL 0.0dB
SW 0.0dB SL 0.0dB
Fader
FRONT : REAR
CH SELECT/ENTER
to select the speaker.
.
CH SELECT/ENTER
to select "Fader".