Multi-Zone Operations; Turning The Power On And Off; Selecting The Input Source; Adjusting The Volume - Denon AVR-989 Owner's Manual

Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT>
<ZONE2 ON/OFF>
<ZONE2 / REC SELECT>
[Front]
[SOURCE
SELECT]
[VOLUME]
[MUTING]
[SOURCE
CONTROL 2]
[SOURCE
CONTROL 1]


Multi-zone Operations

BUTTON

Turning the Power On and Off

<BUTTON>
[BUTTON]
GOperation on the main unitH
<ZONE2 ON/OFF>
Press .
When the power turns on, the multi-zone indicator (
<VOLUME>
the display.
GOperation on the remote control unitH
In the zone mode you want to operate, press
OFF]
.
[SOURCE SELECT]
• Also press
turns on.
• When using ZONE2, it is possible to turn the power for the MAIN
ZONE only on or off by pressing
[Rear]

Selecting the Input Source

[ZONE2 OFF]
GOperation on the main unitH
[ZONE2 ON]
<ZONE2 / REC SELECT>
q Press
[MAIN ON]
SOURCE SELECT
w Turn <
[MAIN OFF]
GOperation on the remote control unitH
[SOURCE CONTROL 1]
q Set
[SOURCE
to "ZONE2".
SELECT]
[SOURCE SELECT]
w Press
) lights on
[ZONE2 ON] [ZONE2
or
when in standby mode, the power
[MAIN ON] [MAIN OFF]
or .
and select the zone to be adjusted.
>.
[SOURCE CONTROL 2]
to "AUDIO" and
.

Adjusting the Volume

GOperation on the main unitH
<ZONE2 / REC SELECT>
q Press and select the zone to be adjusted.
<VOLUME>
w Turn to adjust.
GOperation on the remote control unitH
[SOURCE CONTROL 1]
to "AUDIO" and
q Set
to "ZONE2".
[VOLUME]
.
w Press
[Variable range] – – – –70dB ~ –40dB ~ +18dB
• The volume can be increased up to the value set at menu "Manual
Setup" – "ZONE2 Setup" – "Volume Limit" (vpage 32).
• The ZONE2 volume can be adjusted only when "ZONE2" is selected
at menu "Manual Setup" – "Option Setup" – "Amp Assign"
(vpage 32).

Turning off the Sound Temporarily

[SOURCE CONTROL 1]
to "AUDIO" and
q Set
to "ZONE2".
[MUTING]
.
w Press
The sound is reduced to the level set at menu "Manual Setup"
– "ZONE2 Setup" – "Mute Level" (vpage 32).
To cancel, either adjust the volume or press
The setting is canceled when the zone's power is turned off.
• The source selected for ZONE2 is also output from the recording
output connectors.
• When the input source to which the digital input connectors
(OPTICAL/COAXIAL) are assigned is selected in ZONE2, playback is
only possible if the digital signal being input is in PCM (2-channel)
format.
NOTE
• Digital audio signals input from the HDMI connectors cannot be
played in multi-zone.
• When certain digital signals are being input, noise may be output
from the ZONE2 audio output connectors.
[SOURCE CONTROL 2]
[SOURCE CONTROL 2]
[MUTING]
again.