Checking The Xm Signal Strength And Radio; Presetting Radio Channels (Preset Memory); Listening To Preset Channels - Denon AVR-989 Owner's Manual

Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT>
uiop
<TUNING PRESET> <STATUS>
[Front]
[SAT TU 1/2]
[SHIFT]
[TUNING]
[CHANNEL + –]
uio p
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]

Checking the XM Signal Strength and
Radio ID
BUTTON
1
<SOURCE SELECT>
Either turn
<BUTTON>
to select "XM".
[BUTTON]
2
<STATUS>
Press
display.
The display will switch as shown below, depending on the
reception conditions.
Display
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
4
<STATUS>
Press until the channel you want to check
[Rear]
(example: "XM001") is displayed.
5
[TUNING]
Press and select channel 0 (XM000).
The radio ID is shown on the display.
[NUMBER]
[SAT TU 1/2]
[TUNING]
[MODE]
The strength of both the XM satellite and terrestrial signals can be
uiop checked at menu "Input Setup" – "Antenna Aiming" (vpage 39).
[MEMORY]
[SAT TU 1/2]
or press
until "SIGNAL" appears on the
Status
Radio ID
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
[MEMORY]
Press .
3
[SHIFT]
Press to select the block (A to G) in which the
station is to be preset.
4
[CHANNEL + –] [NUMBER (1 ~ 8)]
Press or
the preset number.
5
[MEMORY]
Press again to complete the setting.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.

Listening to Preset Channels

Operation on the Main Unit
<TUNING PRESET>
Press , then turn
to select the preset channel.
Operation on the Remote control Unit.
1
[SHIFT]
Press to select the memory block (A to G).
2
[CHANNEL + –] [NUMBER (1 ~ 8)]
Press or
the desired preset channel.
to select
<SOURCE SELECT>
to select