Manual Setup; Speaker Setup; Speaker Configuration - Denon AVR-989 Owner's Manual

Manual Setup

Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
SOURCE SELECT <SPEAKERS>
<MENU>
uio p
[Front]
SOURCE
SELECT
uio p

For details on how to select, set and cancel settings for each menu, see "Menu Operations" (vpage 20).
Make detail settings for various parameters.

Speaker Setup

BUTTON
Use this procedure to set the speakers manually or if you wish to
<BUTTON>
change the settings made with the auto setup procedure.
[BUTTON]
F Menu screen F
MENU
1.Auto Setup
2.Manual Setup
3.Input Setup
4.Parameter
5.Information
[Rear]
a Speaker Confi guration
SOURCE
Select speaker confi guration and size.
SELECT
(bass reproduction capability)
Front Speaker
[A. MENU]
Select front speaker size.
uio p
[Selectable items] Large
[TEST]
Center Speaker
Select center speaker use and size.
[Selectable items] Large
Subwoofer
Select subwoofer use.
[Selectable items]
2.Manual Setup
1.Speaker Setup
2.HDMI Setup
3.Audio Setup
4.ZONE2 Setup
5.Option Setup
2-1.Speaker Setup
1.Speaker Config.
2.Subwoofer Setup
3.Distance
4.Channel Level
5.Crossover Freq.
6.Front Speaker Setup
Small
Small None
Yes No
Surround Speaker
Select surround speaker use and size.
[Selectable items] Large Small None
Surround Back Speaker
Select surround back speaker use and size.
(
[Selectable items] Large Small None
( )
2spkrs 1spkr
NOTE
Since "Amp Assign" of AVR-989 is set to "ZONE2" by default, audio
is not output from the surround back speakers. When using the
surround back speakers with MAIN ZONE, change the "Amp Assign"
setting to "7.1ch" (vpage 32).
Large
: Select this when using large speakers with ample low
frequency reproduction capabilities.
Small
: Select this when using small speakers without ample low
frequency reproduction capabilities.
None
: Select this when no speaker is connected.
Yes
: Select this when a subwoofer is connected.
No
: Select this when no subwoofer is connected.
2spkrs 1spkr
:
Select the number of surround back speakers.
Even when the surround back speaker setting is other than
"None", sound may not be emitted from the surround back
speaker, depending on the playback source. In this case, make
a menu "Parameter" – "Surround Parameter" – "SB CH Out"
setting other than "OFF" (vpage 44).
)