Getting Started - Brother GT-782 Instruction Manual

3. Getting Started

３. Getting Started
Before using your printer, it needs to be correctly setup as described in this chapter.
Do not handle the power cord with wet hands, otherwise it may cause electric shocks.
Do not set up the printer in a dusty environment. If dust collects inside the printer, it may cause fire or electric
shocks or problems with correct operation.
Be sure to connect the ground. If the ground connection is not secure, you run a high risk of receiving a serious
electric shock, and problems with correct operation may also occur.
Do not bend the cords excessively or fasten them too hard with staples or anything similar to secure cords,
otherwise there is the danger that fire or electric shocks could occur.
Setting up and moving of the printer should only be carried out by a qualified technician.
The printer machine weighs approximately 230 kg (507 lb). Transporting and setting up of the printer should be
held in proper way. The machine may fall down and cause injury.
The printer must be used on a suitable stable surface, otherwise it may tip over or fall down and cause injury.
Furthermore, the table that supports the printer should be at least 180 cm (70.9 inch) in width and 90 cm (35.4
inch) in depth, and should be able to bear a weight of 250 kg (555 lb) or more.
Do not set up the printer in a place where it will be affected by vibration. It may become unbalanced and fall down,
which cause injury or damage to the printer.
Do not connect the power cord until setup is complete, otherwise the printer may operate if the power switch is
turned on by mistake, which could result in injury.
Do not climb onto the printer or place heavy objects on top of it, otherwise it may become unbalanced and tip over
or fall down and cause injury.
15
WARNING
CAUTION
GT-782