External Controller; Connecting The Power Cord - Denon AVR-2310CI Owner's Manual

ENGLISH

External Controller

RS-232C connector
n
When you connect an external control device, you can control
the AVR-2310CI with the external control device. Perform
the operation below beforehand.
q Turn on the AVR-2310CI's power.
w Turn off the AVR-2310CI's power from the external
controller.
e Check that the AVR-2310CI is in the standby mode.
Set as Necessary
Set this to use the RS-232C connector for the DENON RF remote
controller.
"232C Port" (vpage 35)
When using the AVR-2310CI in combination with the DENON RF
remote controller (RC-7000CI, sold separately) or RF remote receiver
(RC-7001RCI, sold separately), two-way communication is enabled.
The AVR-2310CI's status information as well as iPod and Internet audio
music files can be browsed watching the RF Remote Controller's
display. For details, refer to the operating instructions of the respective
devices.
NOTE
On the GUI menu, when setting "232C Port" to "2Way Remote" , you
cannot use the RS-232C connector as an external controller (vpage
35).
9
REMOTE CONTROL jacks
n
Infrared
Infrared
retransmitter
sensor
Extension jack for future use.
(Connect devices corresponding
with room to room function to
Output
this jack.)
Input
TRIGGER OUT jacks
n
The TRIGGER OUT output terminal outputs a maximum 12
V/150 mA electrical signal. When a device with TRIGGER IN
terminal is connected via a monaural mini-plug, the connected
device's power on/standby can be controlled through linked
operation to the AVR-2310CI.
Set as Necessary
Set to change the conditions for linked operation via the TRIGGER
OUT terminal.
"Trigger Out" (vpage 35)
Connecting Devices not Equipped with HDMI terminals

Connecting the Power Cord

Wait until all connections have been completed before connecting the
power cord.
Power cord
To household
power outlet
(AC 120 V, 60 Hz)
Connection to the AC outlets
• These outlets supply power to external au-
dio equipment.
• Audio equipment with a total power con-
sumption of 120 W (1 A) can be connect-
ed.
• The power supply turns on and off together
with the on the main unit. When set
to "ON" , power is supplied from the outlet.
When set to "STANDB�" , no power is sup-
plied.
NOTE
When "HDMI Control" (vpage 31) is set
to "ON" , power is supplied constantly to
the AC outlet (UNSWITCHED).
NOTE
• Insert the AC plugs securely. Incomplete connections could cause
noise.
• Only use the AC outlets to plug in audio equipment. Do not use
them as power supplies for hairdryers or anything other than audio
equipment.