Denon AVR-2310CI Owner's Manual page 29

STEP5 Check
8
Use ui to select the item you want to check, then
press .
A U T O S E T U P
A U D Y S S E Y A U T O
The measurement result
S T E P 5 C h e c k
confirmation screen is
C h e c k p r o c e s s i n g
u l t s . T o p r o c e e d , p r e s s
displayed.
" N e x t "
S p k r C o n f i g C h e c k
D i s t a n c e C h e c k
C h . L e v e l C h e c k
b
S ubwoofer or other C r o s s o v e r C h e c k
N e x t S t o r e
speakers may be set to
a value that does not
S e l e c t i t e m t o
correspond to the actual
distance.
9
Press .
This returns you to analysis results items, so repeat step 8.
10
Press i to select "Next 1 Store", then press
STEP6 Store
11
Select "Store", then
A U T O S E T U P
A U D Y S S E Y A U T O
press .
S T E P 6 S t o r e
P r e s s " S t o r e " t o
c a l c u l a t i o n r e s u l t s .
"Now Storing... Please
wait." is displayed on the
S t o r e
GUI menu while the results
are being stored.
A p p l y a n d s t o r e
NOTE
Do not turn the power off while the settings are being stored.
12
Disconnect the setup microphone from the AVR-
2310CI.
13
Select "Exit" and then press .
Remote control
operation buttons
Exiting the GUI Menu
n
Press while the GUI menu is displayed.
The GUI menu display disappears.
NOTE
S E T U P M u l t E Q
Do not change the speaker connections or subwoofer volume, or
[ 5 / 6 ]
r e s -
speaker locations after making measurements. If changes are neces-
sary, make the changes and use the Audyssey Auto Setup once again
for an updated EQ solution.
E N T E R E n t e r R E T U R N C a n c e l
c h e c k
• If the result differs from the actual connection status or an error
message appears, use
to repeat the measurement.
• If the result still differs from the actual connection status after re-
measurement or the error message still appears, it is possible that
the speakers are not connected properly. Turn the AVR-2310CI off,
check the speaker connections and repeat the measurement process
.
from the beginning.
• For instance, If the location or direction of a speaker is altered, the
Audyssey Auto Setup should be performed again to ensure the
correct EQ solution for the new room configuration.
S E T U P M u l t E Q
[ 5 / 6 ]
s t o r e
E N T E R E n t e r R E T U R N C a n c e l
m e a s u r e m e n t r e s u l t .
Displaying the menu
:
: Moves the cursor (Up/Down/Left/Right)
Cancel the menu
Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup)
ui
to GUI menu "Retry" and then press
: Decision the setting : Return to previous menu
ENGLISH
2