Denon AVR-2310CI Owner's Manual page 37

Setting items
GUI Format : Set the video signal format to be output for the TV you are
Make the settings related to using.
displays on the TV screen. • NTSC : Select NTSC output.
• PAL : Select PAL output.
The "Format" can also be set by the following procedure. However,
the GUI screen is not displayed.
1. Press and hold Press and hold
"Video Format" appears on the display.
2. Press Press o p
3. Press Press
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
:
Text The mode name is displayed when the operation for switching the
surround mode, input mode, etc., is performed.
• ON : Turn display on.
• OFF : Turn display off.
Master Volume
• Bottom : Displayed at the bottom of the screen.
• Top : Displayed at the top of the screen.
• OFF : Turn display off.
Tuner Information
tuner operation is performed.
A lways : Show display continuously.
•
• 30sec : Show display for 30 seconds after operation.
• 10sec : Show display for 10 seconds after operation.
• OFF : Turn display off.
iPod Information
iPod operation is performed.
A lways : Show display continuously.
•
• 30sec : Show display for 30 seconds after operation.
• 10sec : Show display for 10 seconds after operation.
• OFF : Turn display off.
Remote control
operation buttons
Setting contents
o on the main unit and for at least 3 seconds.
and set the video signal format.
, or to complete the setting.
:
Master volume display during adjustment.
:
This sets the time the GUI menu is displayed when a
:
This sets the time the GUI menu is displayed when an
Displaying the menu
:
: Moves the cursor (Up/Down/Left/Right)
Cancel the menu
Setting items
Quick Select Name Rename Label : Change the display name of the selected "Quick Select"
Change the Quick Select setting.
ui
name. 1. Use to select the name of the Quick Select setting you want
to change, then press
2. Use o p to set the cursor to the character you want to change.
ui
3. Use to change the character, then press
• Up to 16 characters can be input.
• The input character type can be switched by pressing
display name is being changed.
• The types of characters that can be input are as shown below.
GUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZ
GLower case charactersH abcdefghijklmnopqrstuvwxyz
GSymbolsH ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜
GNumbersH 0123456789 (Space)
4. Repeat steps 2 and 3 to change the display name.
Zone Rename ui
1. Use to select the zone name you want to change, then press
Rename the display names
.
of the different zones as
MAIN ZONE / ZONE2
desired.
o p
2. Use to set the cursor to the character you want to change.
3. Use ui to change the character, then press
• Up to 10 characters can be input.
• The input character type can be switched by pressing
display name is being changed.
• The types of characters that can be input are as shown below.
GUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZ
GLower case charactersH abcdefghijklmnopqrstuvwxyz
GSymbolsH ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜
GNumbersH 0123456789 (Space)
4. Repeat steps 2 and 3 to change the display name.
: Decision the setting
ENGLISH
Making detailed settings (Manual Setup)
Setting contents
.
.
while the
.
while the
See overleaf
3
: Return to previous menu