Table of Contents
Advertisement
ENGLISH
Multi-zone
ZONE2 out Connections
If another pre-main (integrated) amplifier is connected, the ZONE2 out
connectors can be used to play a different program source in ZONE2
at the same time (vpage 60 ~ 62).
Pre-main amplifier
(ZONE2)
R
L
Extension jack for future use.
R
(Connect devices corresponding with
L
room to room function to this jack.)
Input
Output
Infrared
retransmitter
NOTE
• For the audio output, use high quality pin-plug cords so that no
induction humming or noise is produced.
• For instructions on installing and operating separately sold devices,
refer to the respective devices' operating instructions.
• To conduct multi-zone playback, see "Amp Assign / Multi-zone
Connections and Operations" (vpage 60 ~ 62).
External Controller
The power of an external device equipped with a trigger input jack
can be turned on and off in association with operations on the AVR-
2309. For details, see menu "Manual Setup" – "Option Setup"
– "Trigger Out" (vpage 31).
• Output: DC 12 V 150 mA MAX.
Check the trigger input conditions of the connected device.
• When using in combination with an RF Remote Controller (RC-
7000CI, sold separately) or RF Remote Receiver (RC-7001RCI, sold
separately) two-way communication with an RF Remote Controller
is possible.
The AVR-2309's status information as well as iPod can be browsed
watching the RF Remote Controller's display. For details, refer to the
operating instructions of the respective devices.
• When used in combination with an RF Remote Controller or RF
Remote Receiver, make the settings at menu "Manual Setup"
– "Option Setup" – "232C Port" – "2Way Remote" (vpage 31).
• On the menu, when setting "Manual Setup" – "Option Setup"
Infrared
– "232C Port" to "2Way Remote", you cannot use the RS-232C
sensor
connector as an external controller (vpage 31).
RS-232C connector
This connector is used for an external
controller.
b If you wish to control the AVR-2309
from an external controller using the
RS-232C
connector,
perform
the
operation below beforehand.
q Turn on the AVR-2309's power.
w Turn off the AVR-2309's power from
the external controller.
e Check that the AVR-2309 is in the
standby mode.
Trigger output jack
Connecting the Power Cord
Wait until all connections have been completed before connecting the
power cord.
Connection to the AC outlet
• This outlet supply power to external audio
devices.
• The power supplied from this outlet turns on
and off together with the set's power switch.
• Audio
equipment
consumption of 100 W (0.43 A) can be
connected.
Power cord
(supplied)
NOTE
• Insert the AC plugs securely. Incomplete connections could cause
noise.
• Only use the AC outlet to plug in audio equipment. Do not use
them as power supplies for hairdryers or anything other than audio
equipment.
Once Connections are
Completed
Turning the Power On
(vpage 46)
with
a
total
power
To household
power outlet
(AC 230 V, 50 Hz)
Advertisement
Table of Contents
