Related Manuals for HySecurity StrongArmPark DC 14
Summarization of Contents
Welcome to HySecurity
Contact Information
Provides contact details for HySecurity distributors and technical support.
Important Safety Information
Safety - Additional Installer Responsibility
Details installer responsibilities for safe and compliant gate operator installation.
Safety - Installer's Responsibility, continued
Continues installer responsibilities, including user demonstrations and site documentation.
Safety - Owner/User Responsibility
Outlines responsibilities for safe operation and maintenance of the gate operator.
Wind Load Factors & Site Prep
Manual Release
Instructions on how to manually operate the barrier arm during power loss or maintenance.
Power
Installing the Earth Ground
Explains the importance and procedure for installing a proper earth ground connection.
Wiring AC Power
Details how to connect the operator to AC power supply, including voltage selection.
Wiring 115VAC Power
Provides specific instructions for connecting the operator to a 115VAC power source.
Wiring 208/230VAC Power
Provides specific instructions for connecting the operator to a 208/230VAC power source.
Connecting DC Power
Steps for connecting the DC power source to the operator.
Turning the Power Switch ON
Explains the operator's behavior and status indicators when power is turned on.
Display & Menu Options
Initial Setup
Guides the user through the initial configuration steps after installation.
Understanding the Display and Keypad
Explains the operator's display interface and keypad functions for navigation.
Menu Mode
Menu Mode Navigation
Details how to navigate through the operator's menu options using the keypad.
Run Mode
Viewing Operator Status Displays
Describes how to view various status information and configurations on the operator display.
User Menu
User Menu: Table 1.
Lists user menu items, setting options, tasks, and SDC wire connections.
Installer Menu
Installer Menu: Table 2.
Details installer menu items, setting options, tasks, and SDC wire connections.
Smart DC Controller Inputs
SDC Terminal Inputs
Provides a chart of SDC terminal inputs, their connections, and common uses.
Photo Eyes (Non-Contact) Installation
Compatibility
Details UL 325 compatibility requirements for photoelectric sensors.
Installation
Steps for installing additional photo eyes for safety and detection.
Configuration
Guides on configuring photo eye settings and connections.
Photo Eye Connections
Instructions for connecting photo eye receiver and emitter wires.
Photo Eye Alignment
Explains how to align photo eyes using the built-in buzzer feedback.
Monitored Connection
Describes how to enable monitored connections for photo eyes.
Photo Eye Function
Explains the behavior of photo eyes during gate operation and fault conditions.
Troubleshooting
System Diagnostic Messages
Explains system alerts, faults, and errors reported by the controller.
General Maintenance
Smart Touch Analyze and Retrieve Tool (S.T.A.R.T.)
Introduces the S.T.A.R.T. software for operator management and diagnostics.
What You Need
Lists the requirements for installing and using the S.T.A.R.T. software.
Installing S.T.A.R.T. Software
Provides step-by-step instructions for downloading and installing the S.T.A.R.T. software.
Software Maintenance
Emphasizes keeping operator software updated for new features and diagnostics.
Electrical Controls
Discusses general maintenance for electrical components and troubleshooting codes.
Clock Battery Replacement
Details when and how to replace the coin cell battery for the clock.
Fuse Replacement
Explains the location and replacement procedure for the SDC's fuse.
Reference
Handing Change
Provides instructions for changing the gate operator's handing configuration.
Need help?
Do you have a question about the StrongArmPark DC 14 and is the answer not in the manual?
Questions and answers