Lexicon MPX R1 - V2 REV User Manual page 25

MPX R1 Version 2 User Guide
23
24
25
26
27
28
29
30
31
32
33
34
5-4
External Pedal Calibration
Calibrates the pedal when Yes/+ is selected. Moving the pedal through its entire
range of travel will re-calibrate the range of the pedal (i.e. 0 for minimum value,
127 for maximum value).
MIDI IN Merge On/Off
When set to On, MIDI data received at the MIDI IN jack will be merged to the MIDI
OUT jack.
MIDI THRU Routing Select
Allows data from MIDI IN (in) or MIDI remote (rE) to be passed to the THRU port.
Relay Mode Select
Allows you to choose how the relay operates. The choices are: 1=latching,
2=momentary normally open, 3=normally closed.
Relay Initialize
Initializes all of the stored relay states. Choices are Yes or No.
Tempo LED On/Off
Allows you to turn the Tempo LED On or Off. The LED is normally On.
Device ID Assign Mode
Sets a Device ID number (0-126) for the remote.
Target ID Assign Mode
Set a Target ID number (0-126) for the remote.
MIDI Dump All
When Yes/+ is pressed, all global settings, system parameters, controller
assignments, relay states and setup information will be dumped via SysEx to the
MIDI OUT port.
MIDI System Dump
When Yes/+ is pressed, all system parameters will be dumped via SysEx to the
MIDI OUT port.
MIDI Controllers Dump
When Yes/+ is pressed, all Controller Assignments will be dumped via SysEx
to the MIDI OUT port.
Detect
The Yes/+ and No/- buttons allow you to select to have the MPX R1 auto-detect
connected MIDI devices (Auto) or to reset the default MIDI Controller assign-
ments appropriate to the MPX 1 (MPX 1) or the MPX G2 (G2). See next page
for a list of controller defaults.
Lexicon
Default: Off
Default: Off
Default: rE
Default: 1
Default: –
Default: On
Default: 0
Default: 0
Default: –
Default: –
Default: –
Default: Auto