Table of Contents
Advertisement
7. Place the screws through the standoff holes on the card and into the
8. Turn each screw clockwise to attach the card to the standoffs.
9. Make sure that all four standoff connections are properly aligned.
10. To secure the connections, tighten the screws firmly, but do not
11. Slide the chassis assembly back into the gateway and resecure the two
Installing a Network Interface Card
All network interface cards (NICs) installed in the Nokia 100i gateway are
installed in the 6U PMC carrier. Ethernet NICs can occupy any of the slots or
subslots in a gateway that other I/O cards do not occupy.
Nokia 100i Installation Guide
standoffs on the motherboard.
Do not tighten completely.
overtighten.
retaining screws.
Reseating the chassis assembly automatically restores power to the
gateway.
The accelerator card is automatically detected and enabled by default.
Installing a Network Interface Card
Screw
Accelerator card
Standoff hole
Motherboard standoff
45
Advertisement
Table of Contents
