Table of Contents
Advertisement
3
Performing the Initial Configuration
Connecting the Console Port
Use the built-in console port to supply the information that makes the gateway
available on the network. Use the built-in serial port (AUX) for
RS232-compliant equipment you are using with your gateway; for example,
as a modem connection for managing the gateway.
Console and AUX Connections"
information for console and serial connections.
Caution
Nokia recommends that you use the console cable that was
delivered with your gateway for your console connection. Otherwise,
ensure that the pin assignments for your cable match those provided
in this section.
Note
Although pin assignments are the same for console and serial
connections, they are used differently by the gateway. Therefore, do not
use these two connectors interchangeably.
Use an ASCII terminal or a computer with terminal emulation software for
console communication.
The following terminal settings are required to communicate with the
gateway by using the console port:
Baud rate
!
!
Data bits
!
Parity
Stop bit
!
!
Flow control
28
9600
—
8
—
none
—
1
—
none
—
"Pin Assignments for
on page 30 provides pin assignment
Nokia 100i Installation Guide
Advertisement
Table of Contents
