Table of Contents
Advertisement
To connect to the console
1. Turn off power to the gateway.
2. Connect the supplied null-modem cable (console cable) to the console
3. Connect the other end of the cable to a system running a
4. If you are using a flash memory card, insert the flash memory card into
Nokia 100i Installation Guide
port.
Note
On the Nokia 100i gateway the console port is located on the front of
the gateway.
Use only the DB-9 port labeled Console; the serial port AUX is an
auxiliary modem port.
If you connect the console port to a data-communications equipment
device, use a straight-through cable.
For cable pin assignments for the console connection,
for Console and AUX Connections"
terminal-emulation program.
the primary flash memory card slot.
The Nokia 100i has slots in the front panel for flash cards.
Note
Nokia recommends that you use the embedded flash memory on the
gateway instead of using the flash memory card. All gateway models
have internal flash memory.
a. Align the card with the slot so that the connector is inserted first.
b. Gently slide the card into the slot and press until you feel it seat into
the slot. If the card does not insert all the way, flip it over and
reinsert it.
Performing the Initial Hardware Configuration
on page 30.
"Pin Assignments
29
Advertisement
Table of Contents
