Table 6: Us Fcc Ids And Industry Canada Certification Numbers And Covered; Configurations - Motorola 5440AP - Canopy 5.4 GHz AP User Manual Supplement

Canopy 400 Series OFDM AP and SM
Table 6: US FCC IDs and Industry Canada Certification Numbers and Covered Configurations
FCC ID Industry
Canada Cert
Number
ABZ89FT7629 ---
--- 109W-5440
6.2.2 Industry Canada (IC) Notification
Industry Canada has not approved these devices for operation in Canada. Until they are
approved, they are not available for sale in Canada, and the information in this section is
provisional and preliminary.
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Users should be cautioned to take note that in Canada high power radars are allocated as
primary users (meaning they have priority) of 5650 – 5850 MHz and these radars could cause
interference and/or damage to license-exempt local area networks (LELAN).
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to RSS-210 of Industry Canada. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio-frequency energy and, if not installed and used in accordance with
these instructions, may cause harmful interference to radio communications.
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment on and off, the user is encouraged to correct the interference by one or
more of the following measures:
Increase the separation between the affected equipment and the unit;
•
Connect the affected equipment to a power outlet on a different circuit from that
•
which the receiver is connected to;
Consult the dealer and/or experienced radio/TV technician for help.
•
To reduce potential radio interference to other users, the antenna type and its gain should be
chosen so its Equivalent Isotropic Radiated Power (EIRP) is not more than that permitted for
successful communication.
Industry Canada Certification Numbers and the specific configurations covered are listed in
6.
Version 1, April 2008
Frequencies Module
Families
10 MHz channels,
centered on 5480- 5440 AP
5710 in 5 MHz
increments (within
the 5470-5725 MHz
5440 SM
U-NII band)
10 MHz channels,
centered on 5480- 5440 AP
5595 and 5655-
5710 MHz in 5 MHz
increments (within
the 5470-5725 MHz
5440 SM
U-NII band with
5600-5650 MHz
excluded)
Antenna, LENS, or Maximum
Reflector Transmitter
Output Power
17 dBi connectorized
antenna (60° x 5° -3
dB beam width)
17 dBi integrated
antenna (18° x 18° -3
dB beam width)
17 dBi connectorized
antenna (60° x 5° -3
dB beam width)
17 dBi integrated
antenna (18° x 18° -3
dB beam width)
If this equipment
Page 33 of 40
User Guide
10 dBm
10 dBm
10 dBm
10 dBm
Table