Motorola 5440AP - Canopy 5.4 GHz AP User Manual Supplement page 30

Canopy 400 Series OFDM AP and SM User Guide
Figure 9: Ground lug highlighted on AP
Unlike standard Canopy APs, the Canopy 400 Series AP have metal-to-metal contact from the
tower or support structure, through the antenna, through the coax cable, to the radio. Due to this,
to provide the best protection from near lightning hits, it is strongly recommended to install surge
suppression at the AP.
The 600SSC surge suppressor replaces earlier surge suppressors, and supports up to three
600SSCs on an Ethernet link in series, for example, a 600SSC within 3 ft (~1 m) of an AP,
another 600SSC where the Ethernet cable enters a telecommunications hut, and the equivalent
of a 600SSC built into each of the 8 ports on a CMM4. A pole mount kit, Model No. SGHN5169A,
is available to facilitiate mounting the 600SSC close (within 3 ft or 1 m) of the AP.
The CMMmicro uses a different protection scheme and and up to 3 600SSCs can be used in-line
on Ethernet links terminated to the CMMmicro.
5.2 INSTALLING AN SM
SM installation is very similar to installing standard Canopy SMs as described in the Canopy
System Release 8 User Guide, with the differences outlined below.
Use an SMMB2 SM mounting bracket, not an SMMB1 typically used with standard Canopy SMs.
The Canopy 400 Series SM is heavier and has a higher windload than a standard SM, and so the
stronger SMMB2 is required. The SMMB2 is the mounting arm used with Canopy 900 MHz
integrated APs and SMs, and used with reflectors.
Use dielectric grease on all connections and in all RJ-45 Ethernet connectors. (Dielectric grease
is generally available in the trade, and is specially formulated so as to be uniformly non-
conducting.) The best practice is to use enough grease to fill the RJ-45 female connector, and
then insert the RJ-45 male connector and push the grease further into the Canopy unit and
around the RJ-45 connector. Excess grease can be wiped over the connector area to provide
some resistance to water ingress around the connector.
Version 1, April 2008 Page 30 of 40