Motorola 5440AP - Canopy 5.4 GHz AP User Manual Supplement page 21

Canopy 400 Series OFDM AP and SM
IMPORTANT!
Operators under regulatory requirements for DFS must ensure the new
Canopy parameter "Region Code" is set correctly. This applies to initial
configuration, after a module is reset to factory defaults, or after a
module is upgraded.
An AP will not transmit if the Region Code is configured to "None".
IMPORTANT!
On APs received from the factory, with Region Code set to "None", the
operator must set the Region Code before the module will transmit. The
same is true of APs which have been reset to factory defaults.
Figure 5: Region Code on AP "Configuration => General" page
Version 1, April 2008
User Guide
Page 21 of 40