Physical Installation; Rack Installation - HP P4522A - Traffic Management Server Sa8220 Getting Started Manual

Physical Installation

Rack
Installation
CAUTION: Do not use
the enclosed small
mounting brackets for
rack installation. These
are used for side rail
installation.
NOTE: These screws are
provided with your rack
hardware, not the
SA8220.
If you have already mounted your system, or if your system does not
require mounting, proceed to "Wiring Connections" later in this
document.
You can physically install the SA8220 in either of two ways. Each
installation method requires a particular type of mounting brackets,
and are included in the SA8220's shipping container.
• In a standard 19" rack, cantilevered from the mounting brackets
• In a cabinet with side rail mounts
Rack mounting requires the use of the large mounting brackets, and
all eight of the included Phillips screws.
1. Locate the two large mounting brackets and the provided screws.
2. Attach a large mounting bracket to each side of the SA8220. Use
four screws to secure each bracket to the holes near the front of
the SA8220, as shown below.
Rack Mounting the SA8220
3. Position the SA8220 in the desired space of your 19" rack and
attach the front flange of each mounting bracket to the rack with
two screws each.
Physical Installation
3