Network Server - HP P4522A - Traffic Management Server Sa8220 Getting Started Manual

Wiring
Connections
NOTE: For more
information about serial
cable failover, see
Chapter 2 in the User
Guide.
1. On the rear of the SA8220, connect the provided AC power
cable.
2. Refer to this diagram for all wiring connections on the front
panel of the SA8220.

Network Server

Network Server
Console Console
Failover Failover
Front Panel Ports and LEDs
3. For Single NIC (Network Interface Card) configurations:
Connect the Network port to your network using the provided RJ-
45 network cable.
For Dual NIC configurations: Connect the Network port to your
outside network, and the Server port to your server side network,
using the provided RJ-45 network cable and a network cable you
provide, respectively.
4. Use the provided serial cable to connect the Console serial port to
the serial port of any terminal or workstation capable of running
a terminal emulator program.
5. If you use cable-based failover to manage a backup SA8220,
connect the second SA8220 in the manner described above and
connect the Failover ports of the two units using the serial cable
provided with the backup SA8220.
6. If the power is not already on, turn on the SA8220 using the
Reset switch on the rear panel.
Physical Installation
Power Power Power
Status Status Status
Act 1 Act 1 Act 1
Act 2 Act 2 Act 2
5