HP P4522A - Traffic Management Server Sa8220 Getting Started Manual page 11

Running Setup Using the Boot Monitor
NOTE: The SA8220 is
not directing traffic when
the Boot Monitor is in
operation.
NOTE: If Autoboot is
enabled, you must first
interrupt the bootup
sequence by pressing a
key at the Press any
key to stop
autoboot prompt. In a
few seconds, the
monitor> prompt
displays. This confirms
that Boot Monitor is
running. Also, this
document assumes that
the SA8220's serial port
is in a secure
environment and no
password is required to
access the Boot Monitor
for initial setup and
configuration. However,
after the device is booted
using either the boot
command in the Boot
Monitor, or the autoboot
function, a password is
required to log on to the
Command Line Interface.
At the first use of the SA8220, you must use the Boot Monitor to
perform the initial configuration.
After entering the initial configuration parameters with the setup
command and booting, the SA8220 is ready for routine operations
using either the Graphical User Interface (see Chapter 4 in the User
Guide) or the Command Line Interface (see Chapter 5 in the User
Guide).
1. Type your information as indicated at the prompts. For example:
monitor>setup
Enable dual NIC operation (yes, no) [no]
--->yes
Auto configure the Network side NIC speed and
duplex? (yes, no) [yes] --->
Auto configure the Server side NIC speed and
duplex? (yes, no) [yes] --->
DHCP is disabled for dual NIC operation.
Enter the hostname you would like to assign to
the Network NIC --->CSLab7k
Enter the IP Address for the Network side NIC
--->10.6.3.21
Enter the IP Address for the Server side NIC
--->10.6.5.21
Enter the Netmask for the Network side NIC
--->255.255.255.0
Enter the Netmask for the Server side NIC
--->255.255.255.0
Enter default gateway --->10.6.3.1
Would you like to configure DNS (yes,no)?
[no] --->
DNS not configured.
Specify failover method (disabled, serial,
route) [disabled] --->
Enable Autoboot? (yes, no) [no] --->yes
Running Setup Using the Boot Monitor
9