Nokia IP290 - Security Appliance Installation Manual page 63

8. Push down on the card until it is properly seated on the motherboard.
9. Place the screws through the standoff holes on the card and into the standoffs on the
motherboard.
10. Turn each screw clockwise to attach the card to the standoffs. Do not overtighten.
Make sure that all standoff connections are properly aligned before tightening the screws
completely.
11. Slide the chassis tray assembly back into the appliance.
12. Resecure the two chassis tray assembly retaining screws.
Note
When you resecure the chassis tray assembly retaining screws, do not exceed a torque
of 4.5 inch-pounds.
13. Replace the power cord.
14. Turn on the power.
15. Configure your software to use hardware acceleration by following the instructions in
"Configuring Software to Use Hardware Acceleration"
Nokia IP290 Security Platform Installation Guide
Replacing a Nokia Encryption Accelerator Card
Screw
Accelerator card
Standoff hole
Motherboard standoff
00175.1
on page 64.
00568
63