Before You Begin - Nokia IP290 - Security Appliance Installation Manual

Before You Begin

To install the accelerator card, you need:
Physical access to the appliance
The Nokia encryption accelerator card and installation kit
Phillips-head screwdriver
Four screws (included in kit)
Grounding wrist strap (included in kit)
Caution
To help guard against electrostatic discharge damage, make sure you are properly
grounded by using a grounding wrist strap and following the instructions provided with
the wrist strap before you handle the components or open the appliance.
To install the accelerator card
1. Use Nokia Network Voyager or the command-line interface (CLI) to perform an orderly
shutdown of the IP290 appliance.
For information about how to access Network Voyager and the related reference materials,
see
2. Turn off the power to the IP290 appliance.
3. Remove the power cord.
Warning
To reduce the risk of fire, electric shock, and injury, disconnect the power cord and any
cables that connect to the appliance or gateway before you open the chassis and
expose internal components. Even though the power switch is turned off, power is still
present inside the appliance or gateway.
4. Loosen the two chassis tray assembly retaining screws.
5. Slide the chassis tray assembly forward and completely remove the chassis to expose the
motherboard components.
Nokia IP290 Security Platform Installation Guide
"Using Nokia Network Voyager"
Replacing a Nokia Encryption Accelerator Card
on page 36.
STATUS POWER
LINK LINK
ACT ACT
RESET
SLOT 1 AUX
Chassis tray assembly retaining screws
IP290
FAULT 1 3 5
CONSOLE
2 4 6
00565
61