Table of Contents
Advertisement
I
NSTALLATION
1. Connect the Connection Cable to the
CONTROL jack of the Transceiver
Body from the Front Panel.
2. Connect an efficient 144/430 MHz an-
tenna, which is adjusted to 50-Ohm
impedance to the ANT jack. Use low-
loss 50-Ohm coaxial cable with type-
M (PL259) connector.
3. Connect the DC power cable directly
to the battery terminals.
Note: Connect the WHITE power
cable lead to the POSITIVE (+)
battery terminal, and the BLACK
power cable lead to the NEGA-
TIVE (-) terminal.
16
C
ONNECTION AND
Antenna
S
ETTING
If you do not use the connector, Attach
the supplied Rubber Cap to the con-
nector.
To mount on a motorcycle, a screw hole
is provided. Refer to image below.
13/32" (10.3 mm) hole - Motorcycle
mounting hole
FTM-10SR O
PERATING
Battery (DC 12 V)
M
ANUAL
Advertisement
Table of Contents
