Tx Meter Selection; Tx Power Adjustment - Yaesu FT-450 Operation Manual

SSB/AM M
You may change the PO meter function to ALC meter or SWR meter in the transmit mode.
By pressing the [ METER/DIM ] button, the meter func-
tion will change as follows.
PO ALC SWR
PO: Indicates the average power output level.
ALC: Indicates the relative ALC voltage.
SWR: Indicates the Standing Wave Ratio (Forward
Power/Reflected Power).
Adjusting the TX output power:
1. Press and hold the [ F ] button for one second to
enter the Menu mode again. The "
will appear on the display.
2. Rotate the [ DSP/SEL ] knob to select the menu
item "RFPOWER".
3. Press the [ DSP/SEL ] knob to enable adjustment
of this menu item. The "
ing.
4. Rotate the [ DSP/SEL ] knob to select the desired
power output.
You may press the [ HOME/RCL ] button to reset
the power output to the factory default.
5. Press the [ DSP/SEL ] knob. The "
turns to appear continuously.
6. Press and hold the [ F ] button for one second to
save the new setting and return to normal opera-
tion.
FT-450 O
TX M
ETER
PWR ......
TX P
OWER
" icon
" icon will be blink-
" icon re-
M
T
ODE RANSMISSION
S
ELECTION
A
DJUSTMENT
[ DSP/SEL ] knob
[ METER/DIM ] button
[ HOME/RCL ] button
[ F ] button
Page 35