Cw Delay Time Setting; Cw Sidetone Volume Level Setting - Yaesu FT-450 Operation Manual

CW M
ODE
During semi-break-in (not QSK) operation, the hang time of the transmitter, after you have finished sending, may
be adjusted to a comfortable value consistent with your sending speed. This is the functional equivalent to the
"VOX Delay" adjustment used on voice modes, and the delay may be varied anywhere between 30 - 3000
millisecond (10 millisecond step) and FULL (Full Break-in operation).
1. Press and hold the [ F ] button for one second to
enter the Menu mode. The "
pear on the display.
2. Rotate the [ DSP/SEL ] knob to select the menu
item "CW DLY".
3. Press the [ DSP/SEL ] knob to enable adjustment
of this menu item. The "
ing.
4. Rotate the [ DSP/SEL ] knob to set the desired de-
lay time.
If the delay selection is set to "FULL", the trans-
ceiver operates in the full break-in mode (allow-
ing you to hear between the characters that are
being sent).
(You may press the [ HOME/RCL ] button to reset
the delay time to the factory default.)
You may adjust the CW sidetone volume level via the Menu Item "CWSTONE".
1. Press and hold the [ F ] button for one second to
enter the Menu mode. The "
pear on the display.
2. Rotate the [ DSP/SEL ] knob to select the menu
item "CWSTONE".
3. Press the [ DSP/SEL ] knob to enable adjustment
of this menu item. The "
ing.
4. While pressing and holding the [ METER/DIM ] but-
ton, rotate the [ DSP/SEL ] knob to set the desired
sidetone volume level (FIX 0 - FIX 100).
If you wish to adjust the CW sidetone level with
the [ AF GAIN ] knob, press the [ F ] key to change
the display to "LNK-xx" then rotate the [ DSP/SEL ]
knob to set the volume ratio of the CW sidetone
volume level for the receiving audio volume level.
Available selections are LNK-50 ~ LNK 0 ~
LNK+50. When the LNK 0 is selected, the CW
sidetone volume level becomes the same as re-
ceiving audio volume level.
(You may press the [ HOME/RCL ] button to reset
the CW sidetone level to the factory default.)
5. Press the [ DSP/SEL ] knob. The "
turns to appear continuously.
6. Press and hold the [ F ] button for one second to
save the new setting and return to normal opera-
tion.
Page 48
O
PERATION
CW D
ELAY
" icon will ap-
" icon will be blink-
CW S V
IDETONE
" icon will ap-
" icon will be blink-
" icon re-
T S
IME ETTING
[ DSP/SEL ] knob
5. Press the [ DSP/SEL ] knob. The "
returns to appear continuously.
6. Press and hold the [ F ] button for one second to
save the new setting and return to normal opera-
tion.
L S
OLUME EVEL ETTING
[ DSP/SEL ] knob
FT-450 O
[ HOME/RCL ] button
[ F ] button
" icon
[ HOME/RCL ] button
[ F ] button
[ METER/DIM ] button
M