Cloning - Yaesu FT-450 Operation Manual

C
LONING
You can transfer all data stored in one transceiver to another set by utilizing the handy "Cloning" feature. This
requires a user supplied cloning cable, which connects the CAT jacks on the two transceivers, as shown below.
To clone from one transceiver to another, use the following procedure:
1. Insert the D-SUB 9pin cross cable (User Supplied)
into the CAT jack of each transceiver.
2. Turn both transceivers off, then press and hold in
the [ MODE ] and [ MODE ] buttons on each ra-
dio while turning the power on again. The "cLonE
C.S-SND" notation will appear on the display.
3. On the "Source" radio, press the [ VOICE/C.S ]
button.
4. Data will now be transferred to the "Destination"
radio from the "Source" radio.
When the clone completes successfully, "CLonE
SENDING" is displayed on the display.
If there is a problem during the cloning process,
"Error" will be displayed. Check your cable con-
nections and try again.
5. If cloning is successful, turn the "Destination" ra-
dio off, and "cLonE C.S-SND" notation will reappear
on the "Source" radio.
6. Turn the "Source" radio off.
7. Remove the clone cable. The channel and oper-
ating data for both radios are now identical. Both
radios may be turned on now for normal opera-
tion.
"Destination"
INPUT
DC 13.8V
2 2A
DATA TUNER LINEAR
Page 86
ANT
EXT
GND
SPKR
CAT
D-SUB 9pin cross cable (User Supplied)
[ ON/OFF ] button
[MODE ] and [MODE ] buttons
"Source" Press the [VOICE/C.S] button
ANT
INPUT
DC 13.8V
2 2A
DATA TUNER LINEAR CAT
FT-450 O
[ VOICE/C.S ] button
EXT
GND
SPKR
M