Marmitek PROGUARD 800 User Manual page 28

This...
OK
TA
BT
OS
NA
The second utility, TX Test enables you to identify transmitters.
In TX Test mode, each time a transmission is received, a chime is sounded and the
activated transmitter is displayed.
To initiate TX Test mode:
1. From the Service menu, select Transmitters, TX Test [7072].
2. Activate a transmitter; the transmitter's details are displayed.
3. When you have finished, press
Audio Volume
To adjust the sensitivity of the microphone and the volume of the speaker:
1. Establish a two-way audio connection.
2. From the Service menu, select Audio Volume [708].
3. Adjust the setting according to the following table.
Press...
1
4
3
6
4. Press ; the new settings are stored in the memory.
GSM Signal Strength
You can measure the GSM signal strength using the system's RSSI (Received Signal
Strength Indication) meter.
To view the GSM signal strength reading:
•
From the Service menu, select
GSM Signal [709]; the signal
strength of the cellular network
is displayed.
Display Version
To display the system's software and hardware versions:
•
From the Service menu, select Version [710]; the software (SW) and
hardware (HW) versions are displayed.
Global Chime
Each sensor can be programmed by your installer to cause the system to chime when
activated. This feature is active only when the system is disarmed. For example, the
system can be programmed to sound a chime each time the front door is opened or
closed. The Global Chime option, enables you to turn this feature on and off.
To enable or disable Global Chime:
1. From the Service menu, select Global Chime [712].
-28-
Means...
The transmitter is functioning correctly
Tamper condition
Battery low
The transmitter is out of
synchronization
The transmitter is inactive
To...
Increase microphone sensitivity
Reduce microphone sensitivity
Increase speaker volume
Reduce speaker volume
to exit TX Test mode.
This reading...
8 to 9
5 to 7
Less than 5
Notify
your
installer
Means...
Reception is good
Reception is acceptable
Reception is unacceptable
© MARMITEK