Zone Bypassing/Unbypassing; User Codes - Marmitek PROGUARD 800 User Manual

7.2: Zone Bypassing/Unbypassing

When a zone is bypassed, its sensor is ignored by the system and does not generate an
alarm when triggered.
To bypass or unbypass a zone:
1. From the Bypass Zones menu, select Bypass/Unbyp. [21].
2. Using the arrow keys, scroll to the zone you want to bypass or
unbypass.
3. Press to change the bypass status.
4. Press ; Save Changes? is displayed.
5. Press
To unbypass all zones:
1. From the Bypass Zones menu, select Unbypass All [22].
2. Press ; all zones are unbypassed
All bypassed zones will be automatically unbypassed when the system is disarmed.
A fire zone cannot be bypassed

7.3: User Codes

The ProGuard800 supports a variety of individual user codes. Each of these codes is
four digits long. Most system functions require you to enter a valid user code.
The ability to perform a function is defined by your user code's authorization level. These
authorization levels are pre-defined for each code as explained below.
Code 1: Master Code
The Master code is the highest user authorization level. With the Master code, you can
edit all other user codes. Additionally, the Master code grants access to the Event Log,
the Service menu and Home Automation Schedule programming.
The default Master code is 1234. Change this code immediately after the system has
been installed!
Codes 2-19: Controlled Codes
When you use a controlled user code for arming and disarming, the system notifies the
monitoring service.
Codes 20-25: Non-controlled Codes
Non-controlled codes do not cause the system to send Arm/Disarm reports to the
monitoring service. The system sends a Disarm report only if you use this code to disarm
the system after an alarm occurrence.
Codes 26-27: Limited Codes
A Limited code enables you to issue a code that is valid for one day only. This code
automatically expires 24 hours after it has been programmed.
Code 28: Duress Code
The Duress code is designed for situations where you are being forced to operate the
system. This user code grants access to the selected operation, while sending a Duress
event message to the monitoring service.
ProGuard800™
to confirm the changed bypass status.
-23-