Declaration Of Conformity For Rf Exposure; Generic Discussion On Rf Exposure; This Device Meets International Guidelines For Exposure To Radio Waves - Cisco Catalyst Wireless 9163E Manual

Table of Contents

Advertisement

Declaration of Conformity for RF Exposure

Figure 18: Brazil Regulatory Information
Portuguese Translation
Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar interferência
em sistemas devidamente autorizados.
English Translation
This equipment is not entitled to the protection from harmful interference and may not cause interference with
duly authorized systems.

Declaration of Conformity for RF Exposure

This section contains information on compliance with guidelines related to RF exposure.

Generic Discussion on RF Exposure

The Cisco products are designed to comply with the following national and international standards on Human
Exposure to Radio Frequencies:
• US 47 Code of Federal Regulations Part 2 Subpart J
• American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers / IEEE
• International Commission on Non Ionizing Radiation Protection (ICNIRP) 98
• Ministry of Health (Canada) Safety Code 6. Limits on Human Exposure to Radio Frequency Fields in
• Australia Radiation Protection Standard
To ensure compliance with various national and international Electromagnetic Field (EMF) standards, the
system should only be operated with Cisco approved antennas and accessories.

This Device Meets International Guidelines for Exposure to Radio Waves

The Cisco Catalyst Wireless 9163E Series Outdoor AP device includes a radio transmitter and receiver. It is
designed not to exceed the limits for exposure to radio waves (radio frequency electromagnetic fields)
recommended by international guidelines. The guidelines were developed by an independent scientific
organization (ICNIRP) and include a substantial safety margin designed to ensure the safety of all persons,
regardless of age and health.
As such the systems are designed to be operated as to avoid contact with the antennas by the end user. It is
recommended to set the system in a location where the antennas can remain at least a minimum distance as
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
70
C 95.1 (99)
the range from 3kHz to 300 GHz
Declarations of Conformity and Regulatory Information

Advertisement

Table of Contents
loading

Table of Contents