H3C S5800-32F Installation Manual page 89

3) Run the terminal emulation program on the PC connected with the switch's console port. Start the
switch and enter the Boot ROM menu. Then enter the protocol parameter setting menu.
If you want to load the Boot ROM file, enter 6 in the Boot ROM menu after the system displays "Enter
your choice(0-9):" to enter the Boot ROM update menu.
1. Update full BootRom
2. Update extended BootRom
3. Update basic BootRom
0. Return to boot menu
Enter your choice(0-3):
4) Enter the protocol parameter setting menu
Enter 1 to update the complete Boot ROM file, and then enter the protocol parameter setting menu.
Bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
5) Configure the switch to upload the Boot ROM file through TFTP
Enter 1 to update the Boot ROM file using TFTP, and then set the TFTP parameters.
Load File Name :update.bin
Server IP Address :10.10.10.2
Local IP Address :10.10.10.3
Gateway IP Address :
The parameters are described in
Table 5-5 Description of the TFTP parameters
Item
Load File Name :
Server IP Address :
Local IP Address :
Gateway IP Address :
Enter the file name and IP addresses based on the actual condition.
If the switch and the server are on the same network segment, you can specify any unused IP
address of the network for the switch without specifying the gateway's IP address; if they are not on
the same segment, you need to specify the gateway's IP address so that the switch can
communicate with the server.
Table 5-5.
Name of the file to be downloaded (for example, update.bin)
IP address of server (for example, 10.10.10.2)
IP address of the switch (for example, 10.10.10.3)
IP address of the gateway (suppose it is not specified)
5-13
Description